Instructions

STEP 13
With the metal shears, cut along the
outside lines along the sides and top.
Do not cut the bottom line!
CAUTION: The cut metal edges are
sharp! Wear gloves to protect hands.
STEP 14
The last cuts are the notches from the
4 corners. Simply cut out the square
that remains in each corner.
STEP 15
Using the included 12 inch sheet met-
al bending tool, bend the sides up 90°
inwards towards the AC coil.
STEP 16
Slide the bottom of the cut panel
into the bottom S-Drive on the back
of the AC coil.
STEP 17
Slide the top S-Drive into the top
from the side. Gently tap the S-Drive
into position with a hammer or mallet
if necessary.
STEP 18
Continue with the (2) Front next,
followed by the (3) left side, nish-
ing with the (4) right side, repeating
STEPS 9 to 17 for each side.
STEP 19
As each completed panel is assem-
bled, be sure to lay the side piece
aps over the front and back panel
aps, for a proper seal.
STEP 20
Using the sheet metal screws and
a screw gun, drive 2 self tapping
screws into each of the overlapping
side seams.
STEP 21
To complete the install, seal all the corners with silicon sealant or foil tape.
Your AC coil to plenum transition kit is installed and complete!
PAGE 3