Owner manual

Introduction
The Model 4185 StripIR infrared heater is a lamp and formed reflector heating system
that provides even heat distribution across a 1.7” wide strip. The Model 4185 heater uses
T-3, halogen lamps backed by a ceramic reflector to provide heat and offer the users
benefits of a high density heating solution.
The Model 4185 StripIR infrared heaters are designed for use in any application that
requires a clean, responsive, non-contact heat source. Some typical applications for the
heater are listed below:
• Curing epoxy
• Curing rubber coating on steel
• Drying and Curing Paint
• Drying and Curing adhesive
• Forming plastic
• Heating acrylic
• Laminating
• Preheating
• Reglossing
• Shrink Insulation
• Thermoforming
• Weld Stress Relief
1-1
Section 1
Figure 1-1: Model 4185 StripIR
Heater.