Use and Care Guide

SECURE FABRIC CAB SKIN TO FRAME (FIG.6)

9. Find the large fabric strap sewn into the bottom rear area

of the fabric cab skin. Pull the strap down and over the

end of both mounting bar ends [C1, C2]. (Fig. 6)

Find all rip and grip tabs on the inside of the cab skin and

secure the skin to the frame.

Note: If it is very difficult to secure straps over the

mounting bar ends, make sure that all rip and grip tabs

are loose and that the skin is fitted correctly.

Fig. 6

FINE TUNE THE PLACEMENT OF THE CAB ON SNOW THROWER AND SECURE

10. Adjust the cab so it is centered over the controls and the angle of the mounting bar ends

are parallel to the ground by loosing the U bolts and mounting clamps and readjusting.

Fully tighten all nuts and screws when complete.

Enjoy your new Snow Thrower Cab!

Loosen nuts to change angle

of mounting bar

Fig. 7

C1, C2