Use and Care Guide

Fig. 3

ASSEMBLE THE REST OF THE FRAME (FIG. 3)

3. Insert the mounting bar ends [C1, C2] into the side mounting

bars by engaging the spring loaded buttons.

4. Insert the front top poles [E1, E2] into the front bottom poles

[D1, D2]. Install each assembled front pole into the vertical

stud on the top of each side of the mounting bar.

5. Insert back hoop side poles [F] into the vertical stud on each

side mounting bar. Insert another pair of back hoop side

poles into the tops of the ones installed on the side mounting

bars. Insert the back hoop corner poles [G] into the tops of

the installed sections of frame hoop side poles. Finish by

inserting the back hoop top pole [H] into both frame hoop

corner poles.

Note: The back hoop side and corner poles each have clear

plastic sleeves on one end. The back hoop top pole [H]

DOES NOT have a clear plastic PVC sleeve.

Note: These parts should

already be installed on

the snow thrower

Remove protective plastic

caps from these metal

studs prior to assembly