User's Manual

Installation of Precise BioAccess¸
2.
1.
Fasten the holder onto the wall.
Mount Precise BioAccess¸
onto the holder.
Torque max 1.0 Nm.
Plug the connector.
4.
3.
1
Do not connect
2
DATA (magstripe) / DATA 0 (Wiegand) OUTPUT
3
CLOCK (magstripe) / DATA 1 (Wiegand) OUTPUT
4
CARD PRESENT OUTPUT
5 Tamper switch loop
6 Tamper switch loop
7 GROUND (power)
8*
Upper red LED (5V = on) INPUT
9*
Upper green LED (5V = on) INPUT
10 POWER 12-24 VDC
5.
Secure Precise BioAccess¸.
Use only screw driver Torx T10.
*See Operation mode on opposite page
access control side of the system. Recomended mounting height 1,4meter/4.6 feet.
Connect the wires using a shielded cable. The shielding must be connected to earth at the