Manualshelf

User Manual

ManualsBrandsPrecise Biometrics ManualsElectronicsFinger Print Reader
11121314151617181920
13
Connecting the Fingerprint Reader to the
Computer
1. Make sure that the parallel port is set to ECP mode.
2. Turn off the computer.
3. Connect the fingerprint reader to the parallel port at the back of the computer
by using the connector. Make sure that the connector is secured, so that it can
not be disconnected by mistake.
4. Unplug the keyboard/mouse PS/2 connector from the keyboard or mouse
port at the back of the computer. Plug the pass-through PS/2 connector from the
fingerprint reader into the keyboard/mouse port instead.
Chapter 2 Installation
parallel port connector
fingerprint reader
Precise 100 A
pass through
PS/2 connector