User Manual

10
Chapter 2
The installation consists of two parts. Start by following the instructions in the Preparing
Installation section. Then continue with the Installing the Fingerprint Identification Software
section.
NOTE: If you are using a Precise 100 A with parallel port connector, it is very important
that the parallel port of the PC is set to ECP mode before using the fingerprint reader.
Otherwise, the fingerprint reader will not function properly. See Setting the Parallel Port in
this chapter.
This chapter includes the following information:
• Minimum system requirements
• Preparing installation
• Setting the parallel port
• Connecting the fingerprint reader
• Installing the fingerprint identification software
• Attaching the fingerprint reader
NOTE: In order to log into your domain server account using your fingerprint:
• the Precise 100 A must be installed on your workstation
• your fingerprints must be registered on the domain server by a domain server
administrator using the Biomanager for Domains or by Personal Enrolment.
Installation
Chapter 2 Installation