Manualshelf

User's Guide

ManualsBrandsPrecise Biometrics ManualsElectronicsUSB Fingerprint Reader Security System
11121314151617181920
11
Chapter 2
The installation consists of two parts. Start by following the instructions in the Preparing
Installation section. Then continue with the Installing the Fingerprint Identification Software
section.
NOTE: If you are using a Precise 100 SC with parallel port connector, it is very important
that the parallel port is set to ECP mode before using the fingerprint reader. Otherwise, the
fingerprint reader will not function properly. See Setting the Parallel Port in this chapter.
This chapter includes the following information:
• Minimum system requirements
• Preparing Installation
• Setting the parallel port
• Connecting the fingerprint reader
• Installing the fingerprint identification software
• Attaching the fingerprint reader
NOTE: In order to log into your domain server account using your fingerprint:
• the Precise 100 SC must be installed on your workstation
• the Precise 100 SC Server must be installed on the domain server
• your fingerprints must be registered by a domain server administrator on the
domain server
Installation
Chapter 2 Installation