User's Guide

Installing the Precise 100 Client Software

NOTE: After installation, the computer has to be restarted before you can use the software.

1. Log into your local computer as administrator. It is strongly recommended that all

Windows programs are closed and no disk is in the disk driver.

2. Insert the enclosed Precise 100 Client software CD into your computer’s

CD-ROM drive. The Master Setup screen appears.

Master Setup screen

NOTE: If the CD does not start automatically, start the CD by clicking Start > Run. Enter

D:\MasterSetup.exe, where “D” is the name of your CD drive. Click OK.

3a. If you have a Precise 100 SC USB reader, connect the fingerprint reader to

your computer. Windows 2000 will no detect the new hardware and install

the necessary drivers from the CD.

3b. If you have Precise 100 SC PAR reader, click the Parallel Driver button to

install the necessary parallel port drivers.

4. If you are using Windows NT you must install the updated Microsoft Smart

Card Base Components, if not previously installed. If you are using Windows

2000 do not install the Smart Card Base Components, the system may crash.

To install the Smart Card Base Components

a) Click the SC Base Components button, a submenu appears.

b) Click the Base Components button in the submenu. You don’t need to

reboot your computer after this step if you continue directly with the

next step.

c) Click the Update button in the submenu and follow the instructions.

Chapter 2 Installation