Manual

Appendix F: MCC iPocket232 User Guide
F-2 Precidia Technologies Inc. 23-CML000293
The modem must be in command mode to receive commands. Any command,
other than the escape sequence (+++), that is sent to the modem while it is in
transmission mode, is transmitted as data.
NOTE: If any characters arrive from the DTE while the modem is executing a
command, such as ATA or ATD, that command is aborted.
Supported AT Commands
Precidia supports a subset of the standard Hayes command set, and a selection of
extended commands, including the ability to initiate and perform FTP and HTTP
transfers (see page F-10).
NOTE: You can test the iPocket232 modem, when not in configuration mode, by
typing AT commands in your terminal software (HyperTerminal, Procomm Plus).
NOTE: Only the options listed under Parameters are valid. Any unsupported
standard command options return an OK result. Any unsupported non-standard
commands return an error result. Options not required are ignored.
The following two tables describe the supported standard AT commands and the
extended AT& and AT+ commands: