Manual

iPocket232 User Guide 5 Configuring the Security Settings
23-CML000293 Precidia Technologies Inc. 43
To access the SNMP Settings, choose SNMP Settings from the Security Settings
sub-menu.
The SNMP Settings sub-menu appears, as shown below.
For details on configuring the SNMP feature refer to the SNMP Settings and
Compliance
Help Guide, available at: http://www.precidia.com/products/documenta-
tion.html.
5.8 IPsec Tunnels #1 and #2
IPsec (Internet Protocol security) refers to a set of specifications for security at the IP
layer of TCP/IP networks. IPsec tunnels are special secure channels of communication
encapsulated within IP protocol that encrypt both the payload data and the packet
header. Encapsulated Secure Payload (ESP) for IP is defined in RFC1827. You can
define up to two tunnels to securely connect the iPocket232 to two separate networks.
IMPORTANT! IPsec contains computationally intensive algorithms. Enabling IPsec
may cause a significant decrease in the speed/performance of the iPocket232. If your
application has performance or latency requirements, please ensure that this decrease
in performance does not break the timing requirements. Full baud rates may not be
achievable when IPsec is enabled.
To access the Secure IP Association settings you must first select an IPsec protocol.
,-----------------------------------------------------------------------------.
| Precidia iPocket232 Configuration v4.03.00 |
|-----------------------------------------------------------------------------|
| Device Settings: | SNMP Settings: |
| | |
| 1) Ethernet: 0.0.0.0 | Community Names: |
| | A) MIBII: (not set) |
| 2) Serial Port: disabled | B) Precidia: (not set) |
| | C) Set: (not set) |
| | |
| | Trap Managers: |
| | D) IP Address #1: 0.0.0.0 |
| *) Save Current Configuration | E) IP Address #2: 0.0.0.0 |
| -) Exit Configuration (no save) | F) Trap Check Interval (s): 0 |
| $) Security Settings | |
| #) System Settings | G) SNMP Trap Settings |
| ?) Refresh this Screen | H) SNMP Allowed Hosts |
`-----------------------------------------------------------------------------'
Change which option?
SNMP Settings Sub-menu