Installation Instructions

Semi-Permanent Removable Threshold
Installation Instructions
Gelcoat & Solid Surface Bathware
PRODUCT MATERIAL AND STRUCTURE
Non-porous ABS cap mounted to a super strong
PVC substrate that will match both gelcoat and acrylic
bathware.
Thank you for purchasing the Semi-Permanent Removable
Threshold. For best results, please read and follow all
directions carefully.
CUSTOMIZING THE SEMI-PERMANENT THRESHOLD
1. Place the semi-permanent threshold into shower to test
t. Although the semi-permanent threshold is pre-cut at the
manufacturer, modications may be necessary for a custom
t. (FIG.A)
2. Mark area that needs adjustment with a pencil. (FIG. B)
A small piece of cardboard can be used to trace the radius
of the area and can then be used as a template or guide
to modify the corners of the semi-permanent threshold
to ensure a good t. (FIGS. C-D) Grinding or sanding the
corners will assure a custom t and installation. (FIG. E)
3. After making the necessary modications, place the
threshold back into the
shower to ensure all
modications are correct
and dry tting the threshold
is accurate.
4. You are now ready to
install the threshold into the
shower.
INSTALLATION OF
SEMI-PERMANENT
THRESHOLD
1. Using a Mildew
Resistant bonding silicone
(white), place a bead
of caulking around the
underside parameters
of the threshold.(FIG. F)
Position threshold into
place. (FIG. G) Remove
excess caulking and
smooth with wet nger
or caulking pallet.
2. Apply a thin bead
of caulking around the
top side of the nished
threshold to seal
between the shower and
threshold. (FIG. H) The
silicone used in Step 1 is
Tools you might need for proper installation
• Pencil
• Grinder or Sander
• Mildew Resistant Bonding Silicone (white)
• Caulk Gun and White Caulk
• Tape Measure
• Two (2) 5”x 5” Cardboard Samples
• Removable Masking Tape
Available only in white
FIG.A
FIG.B
FIG.C
FIG.D
FIG.E
Threshold Part Numbers
• 1THR60
• 1THR48
• 1THR36