Install Guide

TECNOELETTRA s.r.l. via D.Vioni n.5 – 42016 S. Rocco - Guastalla (RE) Tel.[phone] Fax.[phone]
mail: [e-mail] web: www.tecnoelettra.it
Cod. Doc. AT206-origineel E 4 / 4
Mode of operation
Push MAN for the
manual function of
the board; the red
led turns on.
START
GENERATOR
STOP
GENERATOR
SWITCHING ON
GENERATOR
SWITCHING ON MAINS
Display measures
Push MEAS to scroll the
measures
The measure selected is
shows by led positioned
below or laterally to
display
Display alarms
In case of alarm, the display
shows a alarm identification
code: the alarm led turns on.
Verify the type of alarm
using the alarm table in front
of the panel
Push RESET to clear the alarm signal and
put the generator in safety.
WARNING! In case of alarm we suggest to contact the generator manufacturer.
In this example displays “A13” alarm:
“Starting failure”
In this example displays mains
voltage of 230V
WARNING! The generator
could remain in on for several
seconds, according to cooling
time set.
ATTENTION! On web site www.tecnoelettra.it is available the complete manual of the TE806 electronic board.
GENERAL WARNING!
- Read this manual carefully since it is necessary as a guide to the way the product is designed to be used, to its technical features, to supply the instructions for installation,
assembly and use. It is also useful for personnel training, to indicate the maintenance operations, for ordering spare parts and to give indications of the outstanding hazards.
- The manual must always be available for consultation near the panel and kept in a proper manner (in protected, dry places, away from direct sunlight, etc.); it should be
considered as part of the panel and must be "KEPT FOR FUTURE REFERENCE" as long as the equipment is assembled.
- It should be borne in mind that some diagrams it contains have only the purpose of identifying the parts described and therefore might not correspond to your card.
- After opening the package, check the entire unit in case of problems with this unit do not use it until you have consulted an the Retailer or Manufacturer otherwise all warranty
rights will be voided.
- This card has only to be used for the purpose for which it was specifically designed. Any other use shall be considered improper and, therefore, dangerous.
- All operations concerning the installation of the control panel should be carried out by skilled personnel in conformity with present regulations.
- During work it is recommended to keep to the current personal safety rules in force in the country the product is destined for (clothing, work tools, etc.).
- When the unit is working do not use the card parts.
- Never for any reason modify any part of the card (connections, holes, electrical or mechanical devices, etc.) unless duly authorized to do so in writing by manufacturer: the
responsibility deriving from any such action shall fall on the person doing it since he then in fact becomes its manufacturer.
- Before doing any cleaning or maintenance, disconnect the control panel from the power supply.
- Never use the card exposed to sources of heat or under direct hot sunlight
It is wise to remember that should any difficulty arise in its use, installation or whatever, our Technical Service is always at your disposal for any explanations or action.
BOARD IN MANUAL FUNCTION: The operator decide the starter, the stopping and the switching of generator.
BOARD IN AUTOMATIC FUNCTION: The electrical switching board automatically starts the generator in case of the mains
irregularity, and stopping the generator when the mains became normal. The electrical
panel also switching the contactor. If enabled, the automatic test goes on based on
programming.
BOARD IN RESET: Push RESET, if the generator is on, it will be stopped immediately. In this position you can not start the
generator and it is not possible to handle switching.
Table of the parameters can show on display:
V MAINS: Mains voltage
V GEN: Generator voltage
A: Generator output current (only if available)
KVA: Generator power output (only if available)
Hz: Generator frequency
Vdc: Battery voltage
Hours: Generator work hours
If all leds are turned off, the display shows the actual
time.