SDS

1600-0100 PPG PAINTS ULTRA-HIDE ZERO INTERIOR LATEX SEMI-GLOSS BASE 1
Product name
1
Product code
Date of issue
Version
00397506
13 October 2017
Section 15. Regulatory information
SARA 302/304
SARA 304 RQ
:
Not applicable.
Composition/information on ingredients
SARA 311/312
Classification
:
Delayed (chronic) health hazard
titanium dioxide
No.
No.
No.
No.
Yes.
-
Name
Fire
hazard
Sudden
release of
pressure
Reactive
Immediate
(acute)
health
hazard
Delayed
(chronic)
health
hazard
Composition/information on ingredients
All components are listed or exempted.
United States inventory (TSCA 8b)
:
United States
United States - TSCA 5(a)2 - Final significant new use rules:
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
No products were found.
bis(2-(2-methoxyethoxy)ethyl) ether
Listed
Section 16. Other information
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the Prevention of Pollution From Ships, 1973
as modified by the Protocol of 1978. ("Marpol" = marine pollution)
Hazardous Material Information System (U.S.A.)
0
0
0
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Date of previous issue
No previous validation
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks. Although HMIS® ratings and the associated label are not required on MSDSs or products leaving a facility under 29 CFR 1910.1200, the
preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark
and service mark of the American Coatings Association, Inc.
The customer is responsible for determining the PPE code for this material. For more information on HMIS®
Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Organization that prepared
the MSDS
:
EHS
:
:
:
:
:
:
3
*
3
0
( * ) - Chronic effects
United States
Page: 11/12