Use and Care Manual

PPG TIMELESS Advanced Oil Technology Luxury Wood Finish & Sealant In One
GENERAL DESCRIPTION
PRODUCT DATA
RECOMMENDED SUBSTRATES
FEATURES / BENEFITS
PPG TIMELESS Satin Semi-Transparent is a distinctive, high-end
satin finish that brings the luxury look of interior hardwood to exterior
spaces. Apply to give your decking the warm, rich look of reclaimed
wood floors. Recommended for use on decks, fences, siding, outdoor
furniture, exterior doors, garage doors and more.
Wood Siding
Pressure-treated wood Railings
Decks Plywood
Fences Outdoor Furniture
PRODUCT TYPE: Alkyd Resin
GLOSS: Satin
VOLUME SOLIDS*: 58% +/- 2%
WEIGHT SOLIDS*: 65% +/- 2%
VOC: <350 g/L (2.92 lbs./gal.)
WEIGHT/GALLON*: 8.0 lbs. (3.6 kg) +/- 0.2 lbs. (91 g)
*Product data calculated on product PPG4015.
COVERAGE: Approximately 350 to 450 sq. ft. (33 to 42 sq. meters) per
gallon (3.78 L) depending upon application, wood texture and porosity.
Coverage figures do not include loss due to surface irregularities and
porosity or material loss due to application method or mixing.
DRYING TIME: Normally dries to touch and recoat in 24 hours at 77°F
(25°C) and 50% relative humidity. Allow 72 hours before light foot traffic.
Wait seven days after applying the second coat to replace furniture.
Drying times listed may vary depending on temperature, humidity, color,
film build and air movement.
CLEANUP: Clean brushes and tools with mineral spirits.
DANGER - RAGS, STEEL WOOL OR WASTE SOAKED WITH PPG
TIMELESS STAIN MAY SPONTANEOUSLY CATCH FIRE IF IMPROP-
ERLY DISCARDED. IMMEDIATELY AFTER EACH USE, PLACE
RAGS, STEEL WOOL OR WASTE IN A SEALED WATER-FILLED
METAL CONTAINER.
DISPOSAL: Contact your local environmental regulatory agency for
guidance on disposal of unused product. Do not pour down a drain or
storm sewer.
FLASH POINT: 136ºF (58ºC
PRODUCT INFORMATION
PPG4015 Honey Pine (Also Tint Base)
PPG4035 Warm Teak (Also Tint Base)
Refer to the appropriate color formula book, automatic tinting equip-
ment, and or computer color matching system for color formulas and
tinting instructions.
PPG4015
TIMELESS
™
PPG4015
Strong protection against the elements
Provides powerful mold & mildew-resistant finish
Powerful UV absorbers protect color & wood
Alkyd resin protects against cracking, splitting & warping of wood
LIMITATIONS OF USE
FOR EXTERIOR USE ONLY.
Apply when air and surface temperature is between 50°F (10°C) to
90°F (32°C). Do not apply in direct sunlight, if rain, snow, heavy dew
or low temperatures below 40°F (4°C) are expected within 48 hours.
While this product provides a mildew resistant coating, growth may
still occur if the substrate is not properly prepared prior to painting
and/or if the substrate is consistently exposed to conditions con-
ducive to mold, mildew, and algae. Examples of these conditions
include, but are not limited to, under eaves, behind shrubbery and
trees, and in areas that are consistently damp with little to no direct
sunlight.
Not recommended for recently painted or sealed surfaces. Do not
use on plastic, rubber, asphalt, tile, vinyl, concrete or any non-porous
surface.
PACKAGING
1-Gallon (3.78 L)
Read Label and Material Safety Data Sheet prior to use. See other cautions on last page.