Operation Manual

1. Introduction
UP! 3D Printer User Manual 3
1. Introduction
1.1 How to use this manual
This User Manual is divided into four sections which cover the Introduction,
Overview, Operation, and Troubleshooting. Please study this manual carefully
before installation, and use the printer according to these instructions. Keep
this manual handy and refer to it when necessary.
1.2 Precautions
Please read this section carefully before using the printer.
1.2.1 Safety
 The printer can only be used with the power adapters supplied by this
company, or the product may be damaged, with a risk of fire.
 To avoid burning, or model deformation, do not touch the model, nozzle, or
the platform by hand, or any other part of the body, while the printer is
working or immediately after it has finished printing.
 Protective glasses should always be worn when removing support material,
especially PLA.
 The brown sections of the currently supplied gloves melt at around 200
degrees, therefore please do not hold the extruder block with the gloves.
 There is a slight smell from ABS when it is being extruded. The smell is,
however, not too unpleasant. A well ventilated room is recommended by
most people to be safe, however when printing keep the printer away from
any draughts as this can affect the warping of ABS prints. When ABS is
burnt is releases toxic fumes.
The following classifications are used in this manual.
CAUTION: Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.