Operation Manual

3. Operation
UP! 3D Printer User Manual 29
The ―Bottom‖ button returns the platform to the lowest position.
Set Nozzle Height: Takes whatever value you have in the ―To‖ box and
transfers it to the Nozzle box of the setup screen.
3.3.5 Preparing the Platform
Before printing, the platform must be prepared so that the model adheres to
the platform enough to be printed without the model moving. You can see six
clips in the box, used to make the perfboard fix on the platform.
The perfboard is cut at 45 degrees angle with the edge, and just fits the size of
the platform. When printing starts, plastic will have more chance to be pushed
into all perforations, and this provides a stronger mechanical bond with the
bottom surface that prevents it from later lifting.