Operation Manual

3. Operation
UP! 3D Printer User Manual 25
The path in the above picture is thick, seems just stick on the surface of the
perfboard, and it can be easily pulled by nails. So click ―No‖, the height will
increase 0.1mm and test again.
The last path in the above picture is quite wide and thin, and its surface is not
flat. Viewed from the side, some of the materials have been plunged into the
little holes of perfboard. And try to remove it by nails, if you cannot pull it out,
click ―Yes‖. The nozzle height is well set.
NOTE: Once you have setup the nozzle height once, you do not need to
do it again as it is automatically recorded in the “Print” Screen.
TIP: You may need to regularly recalibrate nozzle height after moving the
printer, or if you find the models are not adhering to the platform properly,
or are warping.
TIP: If you happen to crash the platform into the nozzle while making height
adjustments, it is good practice to re-initialize the printer before
undertaking any other operations.