Operation Manual

3. Operation
UP! 3D Printer User Manual 10
Platform: Raise the platform axis to a height at which you can reach under it
to insert the screws. Line up the screw holes (e, f) on the platform with the
screw holes on the heater base and insert the screws in from the bottom and
tighten them.
Perfboard: Fix the perfboard on the platform with 4 clips at each corner. (see
3.3.5)
Roller shaft: Unscrew the screw (b) from the printer, and then fix the roller shaft
with the screw. Please note that the roller shaft should lock into the screw (a).
Material Extrude (top view)
(1) Connect the power adapter to the power interface.
(2) Insert the end of ABS filament into the Filament tube.
(3) Start the UP! Software (refer to the software install procedure in 3.1.2 if you
have not already installed it), and press the ―Extrude‖ button in the
―maintenance‖ dialogue box, which is accessed from the ―3D Print‖ menu.
(4) After the printer nozzle has warmed up to 260°C, the printer will beep. Push