User manual

UP Plus 2 3D Printer User Manual v 2013.10.24
Example of a good extrusion after doing an extrude.
8.1 Withdrawing filament from the Extruder
Click on the menu “3DPrint” -> “Maintenance” -> “Withdraw”. The printer extruder will now
start to heat. (Takes approximately 10mins)
After the printer nozzle has warmed up to 260°C, the printer will beep. Gently pull out the fila-
ment from the top of the extruder head. After the printer beeps a second time (meaning the extru-
sion process is complete), pull away the piece of filament. Cut the end of the filament flat.