User manual

UP Plus 2 3D Printer User Manual v 2013.10.24
(Windows version) (Mac version)
5.2 Initialise with front switch
If the printer has just been turned on (in sleep mode), you can initialise the printer by pressing
down the front switch.
To cancel a print job, hold down the front switch for 5 seconds, the platform will then lower and
the printer will enter sleep mode.
6. Levelling the platform (Automatic, Soft-
ware or Physical methods)
There are three different methods to level the platform, the easiest method is automatic when using
the UP Plus 2. Software and Physical levelling sections can be skipped.
6.1 Automatic Levelling
1. Ensure your Perfboard is clean and smooth both sides,
as a small piece of plastic could cause the levelling to
be uneven.
2. Plug in the black calibration wire into the back of the
printer.