User manual

UP Mini
3D Printer User Manual
8.6 How to
remove
First “Withdraw” the filament from the extruder. Once the
printer beeps remove the filament from the extruder head.
If you only need to
remove the extruder block, then just follow
the last step below.
Switch off at the back of the printer and wait for the extruder to
cool down.
Remove the extruder head from the printer’s magnetic mount
and set on your desk.
Unplug the yellow extruder
Remove the two Alan
screws
from above the fan that hold the white
Note: Please take extra care with the wires that connect to the
extruder block, they are fragile!
Slide the white plastic part away from the stepper motor.
Lay the opened parts on your desk.
go into the heat sink.
(using the middle sized Alan key)
Note: Please take extra care with the wires that connect to the
extruder
block, they are fragile!
Loosen the two small Alan screws
key)
You will now be able to slide the extruder block out.
Note: Please take extra care with the wires that connect to the
extruder block, they are fragile!
4. Troubleshooting
3D Printer User Manual
remove
the drive cover and
extruder block
First “Withdraw” the filament from the extruder. Once the
printer beeps remove the filament from the extruder head.
remove the extruder block, then just follow
Switch off at the back of the printer and wait for the extruder to
Remove the extruder head from the printer’s magnetic mount
Unplug the yellow extruder
block cable.
screws
(using the middle sized Alan key)
from above the fan that hold the white
plastic.
Note: Please take extra care with the wires that connect to the
extruder block, they are fragile!
Slide the white plastic part away from the stepper motor.
Lay the opened parts on your desk.
Remove the two screws that
(using the middle sized Alan key)
Note: Please take extra care with the wires that connect to the
block, they are fragile!
Loosen the two small Alan screws
(using the small sized Alan
You will now be able to slide the extruder block out.
Note: Please take extra care with the wires that connect to the
extruder block, they are fragile!
4. Troubleshooting
53
extruder block