User manual

UP Mini
3D Printer User Manual
Support Options
(Smart Support)
The software’s Smart Support is where the
software will automatically calculate where it
requires support material. The Bunny on the
left was printed with 80 degree support and
then the support material is broke
reveal the end result
on the right
mended setting is 30 or 10
degrees.
Support
Angle
at
support material only gets used if angle of surface is
horizontal
hang), If set to 50°
than support material is used for any surface
horizontal.
In the image on the left of a green curve, the red indicates the amount of support
material, changing the angle higher will produce more support.
Set to > 10°
3D Printer User Manual
Semi-Hollow Honeycomb
Hollow Honeycomb:
The Part is made
low, which gives you the weakest
part
time.
Parts with flat top surfaces can
with this setting.
(Smart Support)
The software’s Smart Support is where the
software will automatically calculate where it
requires support material. The Bunny on the
left was printed with 80 degree support and
then the support material is broke
n away to
on the right
. The recom-
degrees.
Support
Angle: (Recommended Angle:30)
at
which support material gets inserted
. For example if 10
support material only gets used if angle of surface is
greater
horizontal
(so support material is almost not used unless there is a direct ove
than support material is used for any surface
that
is greater than 5
In the image on the left of a green curve, the red indicates the amount of support
material, changing the angle higher will produce more support.
Set to > 50°
34
The Part is made
mostly hol-
part
but faster print
Parts with flat top surfaces can
slightly droop
. For example if 10
° is used,
greater
than 10° from
(so support material is almost not used unless there is a direct ove
r-
is greater than 5
0° away from
In the image on the left of a green curve, the red indicates the amount of support