User manual

UP Mini
3D Printer User Manual
5. Load the spool
of filament
Check the diagram for the correct orientation
spool..
6.
Feed the end of the filament
Feed the filament
through the feeder
about 10cm out the other end of the tube.
7. Place the F
ilament and tube inside the back of the top
door.
8.
Push the end of the filament into the print head feed
hole.
9.
Slide the Perfboard into the platform
groves) and attach the binder clips
to hold the Perfboard
Perfboard
after printing
the printer.
3D Printer User Manual
of filament
onto the back of the printer.
Check the diagram for the correct orientation
of the
Feed the end of the filament
through the filament guide.
through the feeder
tube and feed
about 10cm out the other end of the tube.
ilament and tube inside the back of the top
Push the end of the filament into the print head feed
Slide the Perfboard into the platform
slots (between the
groves) and attach the binder clips
on the front in order
to hold the Perfboard
in place. Always remove the
after printing
to remove printed models from
14