Operation Manual

1. Introduction
UP! mini 3D Printer User Manual 3
1. Introduction
1.1 How to use this manual
This User Manual is divided into four sections which cover Introduction,
Overview, Operation, and Troubleshooting, respectively. Please read this
manual carefully before install and operate this machine. Keep this manual
handy and refer to it when it is needed.
1.2 Precautions
Please read the following precautions carefully before operating the printer.
1.2.1 Safety
 UP! printer can only be used with the power adapters supplied by Tiertime.
Other adapters could damage the printer with risk of fire.
 During the period that printer is printing, and just after printer is done
printing, print platform, nozzle and printed model are still hot. In order to
avoid being burnt or cause deformation of model, do not touch model,
nozzle, or print platform by hand without any protection.
 Protective glasses should always be worn when removing support
structure, especially when printing material is PLA.
 The melting point of the brown sections of protection gloves supplied with
the printer is about 200°C . Please do not hold the nozzle with the gloves
when nozzle is heated.
 Slight smell will be generated from printing material when printer is
extruding filament. A well ventilated room is highly recommended.
The following icons are used in this manual:
CAUTION: Indicating potential hazardous situation in which, if not
avoided, may cause minor or moderate injury.
WARNING: Indicating potential hazardous situation in which, if not
avoided, may cause serious injury.