Specification Sheet

Regulatory Compliance: RoHS 2011/65/EU Compliant | ISO 9001:2015

Document version: TS-MIMO-0003-V2-15 REV2

www.poynting.tech

MIMO-3-V2-15

Product Specifications may change without prior notice

Revised: August 2018

MIMO-3-V2-15

ANTENNAS | MIMO-3-V2-15

5 - IN - 1 TRANSPORTATION & AUTOMOTIVE ANTENNA

2X2 LTE (MIMO), 2X2 DUALBAND WIFI (MIMO), GPS/GLONASS

A P P LI CA TI O N AR E A S

410-470; 690-960;

1710-2700 & 3400-

3800 MHz

5.8 dBi

21 dBi

7 dBi

Increase

x Mb/s

Omni-Directional

Machine to

Machine

IP 68

Urban

2.4-2.5 & 5.0-6.0

GHz

-40°C to +80°C

UL 94 HB

2x2 MIMO

GPS included

Rural/Farm

• 5-in-1 high performance multi frequency 2G/3G/4G/LTE antenna

(5G Ready)

• 2 x MiMo LTE, 2 x MiMo WIFI & GPS / GLONASS

• Ultra-Wideband, includes 450MHz and 3.5GHz CBRS Bands

• Robust and water resistant (IP68) antenna

• Ideal for transportation & marine use

• Multi mounting options for easy installation

Marine

Transportation

Product Overview

The MIMO-3-V2-15 consists of a 5-in-1 antenna system within a single housing, providing 2x Cellular, 2x Wi-Fi and a GPS/GLONASS. This antenna

is specifically designed for the transportation and marine industry. The 2x Cellular MIMO antennas (for 2G/3G/4G) covers the contemporary

690MHz to 2700MHz bands, as well as the new emerging LTE and 5G spectrum for 450MHz and 3.5GHz CBRS bands, which is becoming

popular across the various international cellular network operators for LTE. This antenna, due to its wide band capabilities, can be used across

different operators and technologies and is ready for future cellular technologies such as 5G up to 3.8GHz. The antenna provides two

separate dual-band Wi-Fi antennas, providing concurrent 2.4GHz and 5GHz on each antenna with 2x2 MIMO capability. The fifth antenna is

a high-performance active GPS/GLONASS system operating down to -40 degrees. The antenna exceeds the performance of most

competitors due to the attention to the design of this high-performance antenna. The radiation patterns of all radiating elements provide an

excellent balance between omnidirectionality, pattern diversity and good radiation abilities at the desired elevation, which is important for

this type of antenna, especially for the transportation and marine market. Main applications are for commercial/industrial vehicles, marine,

M2M and other IoT systems using a wide range of radio technologies, while remaining futureproof over the wide frequency band offered by

this antenna.

Features

• Ultra-wideband 410MHz to 470MHz, 690MHz to 2700MHz

and 3400MHz to 3800MHz bands

• Cleverly designed decorrelated antennas give superior

MIMO performance in both Wi-Fi (dual band) and cellular

bands

• Above features maintained from 698MHz to 5800MHz in

relevant bands, including the 450MHz band

• Careful mechanical design provides ruggedness,

corrosion, water, dust resistance (IP68)

Application Areas

• Transport broadband and Wi-Fi distribution, automation

and telemetry for Busses, Utility, Trucking & Public Safety

vehicles

• Industrial factory automation, robotic machinery and

other M2M systems telemetry

• Farming & Agricultural automation such as M2M & IoT

• Broadband cellular to WiFi distribution for Marine / Boats

(inland and near coastal vessels)

• Mining Vehicles & Machinery communications, telemetry

and automation (M2M & IoT)

Summary of content (9 pages)

PAGE 1
MIMO-3-V2-15 ANTENNAS | MIMO-3-V2-15 5 - IN - 1 TRANSPORTATION & AUTOMOTIVE ANTENNA 2X2 LTE (MIMO), 2X2 DUALBAND WIFI (MIMO), GPS/GLONASS 5.8 dBi 21 dBi 7 dBi Increase x Mb/s 4x Omni-Directional Machine to Machine 2.4-2.5 & 5.0-6.0 GHz -40°C to +80°C UL 94 HB 2x2 MIMO GPS included • • • • • • IP 68 5-in-1 high performance multi frequency 2G/3G/4G/LTE antenna (5G Ready) 2 x MiMo LTE, 2 x MiMo WIFI & GPS / GLONASS Ultra-Wideband, includes 450MHz and 3.
PAGE 2
MIMO-3-V2-15 Frequency Bands – Cellular & Wi-Fi The MIMO-3-V2-15 is suitable for the following Cellular frequency bands |410-470 MHz| 690-960 MHz | 1710-2170 MHz|2300-2500 MHz|2500-2700 MHz|3400-3800 MHz| and the following Wi-Fi frequency bands |2400-2500 MHz| 5000-6000 MHz| Indicates the frequency bands which MIMO-3-V2-15 supports Indicates the frequency bands which MIMO-3-V2-15 supports Antenna Overview Ports SISO / MIMO Frequency Bands Peak Gain Coax Cable Type Coax Cable Length Connector Type 1&2
PAGE 3
MIMO-3-V2-15 Electrical Specifications - Cellular Frequency bands: Coax Cable & Connector Type - GPS 410-470 MHz 690-960 MHz 1710-2700 MHz 3400-3800 MHz Gain (max) Port 1 & 2: 5.8 dBi Cable length: 2m ±5% Coax cable type: RTK-031 Connector type: SMA (Male) *The coax cables & connectors are factory mounted to the antenna VSWR Port 1 & 2: ≤2.5:1 Feed power handling: Input impedance: Polarisation: Coax cable loss: 10 W 50 Ohm (nominal) Linear Vertical 0.35 dB/m @ 900 MHz 0.53 dB/m @ 2000 MHz 0.
PAGE 4
MIMO-3-V2-15 Technical Drawings Antenna Performance Plots Voltage Standing Wave Ratio (VSWR)* Gain in dBi VSWR is a measure of how efficiently radio-frequency power is transmitted from a power source, through a transmission line, into a load. In an ideal system, 100% of the energy is transmitted which corresponds to a VSWR of 1:1. 5.8 dBi is the peak gain across all bands from 410-470, 690-960 1710-2700 & 3400-3800 MHz The MIMO-3-V2-15 delivers superior performance across all bands with a VSWR of ≤2.
PAGE 5
MIMO-3-V2-15 Voltage Standing Wave Ratio (VSWR)* Gain in dBi VSWR is a measure of how efficiently radio-frequency power is transmitted from a power source, through a transmission line, into a load. In an ideal system, 100% of the energy is transmitted which corresponds to a VSWR of 1:1. 7 dBi is the peak gain across all bands from 2400-2500 & 5000 – 6000 MHz The MIMO-3-V2-15 delivers superior performance across all bands with a VSWR of ≤2.
PAGE 6
MIMO-3-V2-15 Radiation Patterns – WiFi MIMO-3-V2-15 ©2018 Poynting Antennas (Pty) Ltd. All rights reserved Product Specifications may change without prior notice Revised: August 2018 Regulatory Compliance: RoHS 2011/65/EU Compliant | ISO 9001:2015 Document version: TS-MIMO-0003-V2-15 REV2 www.poynting.
PAGE 7
MIMO-3-V2-15 Radiation Patterns – GPS MIMO-3-V2-15 ©2018 Poynting Antennas (Pty) Ltd. All rights reserved Product Specifications may change without prior notice Revised: August 2018 Regulatory Compliance: RoHS 2011/65/EU Compliant | ISO 9001:2015 Document version: TS-MIMO-0003-V2-15 REV2 www.poynting.
PAGE 8
MIMO-3-V2-15 Mounting Options Standard Spigot Mount Threaded Spigot Mounting Surface Mount Adhesive Surface Mounting Magnetic Mount Optional Magnetic Base Kit MIMO-3-V2-15 ©2018 Poynting Antennas (Pty) Ltd. All rights reserved Product Specifications may change without prior notice Revised: August 2018 Regulatory Compliance: RoHS 2011/65/EU Compliant | ISO 9001:2015 Document version: TS-MIMO-0003-V2-15 REV2 www.poynting.
PAGE 9
MIMO-3-V2-15 Additional Accessories A-MBK-0001-V1.0 Magnetic Base Kit A-CAB-118 5 x 5m Extension cables for 5-in-1 Antennas A-CAB-119 5 x 3m Extension cables for 5-in-1 Antennas Contact Poynting Poynting Antennas (Pty) Ltd - Head Office Poynting Europe Unit 4, N1 Industrial Park Regus Business Center Neue Messe Riem Landmarks Avenue, Kronstadter Straße 4 Samrand, 0157 81677 München South Africa Germany Phone: +27 (0) 12 657 0050 Phone: +49 89 208026538 E-mail: sales@poynting.co.