Product Manual

1. The filter in the solution tank (FIG 3) should be kept clean. It can be removed if

necessary. A damaged filter should be replaced, otherwise blockages and/or

damage to the pump head and spray jet can occur.

2. Check the spray jet (FIG 4) for blockage and a uniform spray pattern. Remove jet

and blow through to clean. Do not use a pin or other sharp objects as this may

cause damage to the jet.

3. Check and remove any debris or lint build-up from the vacuum head, brush, and

brush housing.

4. Always wash out the tanks with clean water after use. To do this, pour clean

water into the solution tank and spray through spray tip to clear chemical residue

from the pump, lines, and spray tip. Allow the vacuum to run for a few minutes

after use to aid the machine in drying out and to help prevent bacteria and

odors.

5. Wash out mesh filter in RECOVERY TANK of dirt and carpet fibers after dumping

waste from recovery tank. Failure to clean filter may cause damage to vacuum

motor.

1. Inspect hoses (unseen blockages sometimes occur), hose cuffs, and the rubber seal on the recovery tank lid. The main

cable, plug, and switches should also be examined for damage.

NOTE: It is advisable to store the unit with the recovery tank lid removed.

CAUTION: THIS UNIT MUST BE PROTECTED FROM FREEZING. Damage from freezing could cause machine to malfunction.

ROUTINE MAINTENANCE INSTRUCTIONS

STORAGE

DAILY / INTERVAL

WEEKLY

WHEN CLEANING IS FINISHED:

1. Disconnect the SOLUTION HOSE on the front of the machine by pushing in on

the ring of the solution fitting.

2. Connect the drain hose (clipped to the back) to the SOLUTION HOSE fitting

and place the other end into the RECOVERY TANK. Press the SOLUTION

switch to the “right” position. This will activate the motor to pump any

remaining solution into the RECOVERY TANK for easy drainage.

3. When all of the solution is pumped from the SOLUTION TANK, turn the

SOLUTION switch off, remove the power plug from the outlet and empty the

RECOVERY TANK. Leave the RECOVERY TANK open when storing.

4. Disconnect the DRAIN HOSE by pushing in on the ring of the SOLUTION

HOSE fitting. Replace the DRAIN HOSE in the clip on the back of the machine,

and re-connect the SOLUTION HOSE.

FIG. 2

FIG. 3

FIG. 4

SOLUTION SPRAY JET

GENERAL INSTRUCTIONS