Product Manual

8
CARE OF THE MACHINE
Warning! Before cleaning the machine, switch off the machine and unplug from the electrical supply.
(viii)
3
2
1
(ix)
(x)
(xi)
1. Move the Transport / Working mode control knob to BOTTOM (Transport) position
(Fig-viii).
2. Disconnect the power supply by unplugging the electrical plug and wind the cable
over cable holders in the handle.
3. Pull out the dirty water tank and wash it completely.
4. To prevent possible clogging of filter, drain cleaning liquid and keep the fresh water
tank clean.
5. Remove the brushes by pushing the brush shaft out (Fig-ix).
6. Wash the brushes either by dipping in a bucket/sink or in running water (Fig-x).
7. Turn the machine sideways and wipe clean the conveyor and machine body with a
damp cloth (Fig-xi).
8. Re-install the brushes after washing. It is easier to push the brush shaft from the
right hand side (identified by the electrical cable).
9. Store the machine in a dry indoor area only.
MAINTENANCE
Warning! Before undertaking any maintenance operations or adjustments, switch off the machine and
unplug from the electrical supply.
• Power cord
Regularly inspect power cord, plug and strain relief for damage or loose connection.
• Brushes
For maximum life, wash the brushes regularly. Ensure machine is in Transport mode when not in use. Store
additional brushes in a vertical position to avoid bending of bristles. Check for permanent bending of bristles
in a particular direction. This may occur if the machine is operated for several days without removing the
brushes, which is not recommended. If this occurs, reverse the brush so that the bent bristles are automatically
straightened.
• Wiper Blade
After years of use the wiper blade may wear. If this occurs the water collection performance will decrease. It
should be replaced by an authorized service agent.
• Solutiontanklter
The filter prevents clogging of the drip holes in the tank. Periodically clean the filter to ensure uniform discharge
of liquid. In case of non uniform discharge from the drip holes, back flush the tank in running water. Clean the
drip holes using wire or a blunt pin.
(viii)
3
2
1
(ix)
(x)
(xi)
(viii)
3
2
1
(ix)
(x)
(xi)
(viii)
3
2
1
(ix)
(x)
(xi)