Product Manual

ManualsBrandsPowr-Flite ManualsFloor Machine14 in. Multiwash Micro-Automatic Scrubber

Warning! This machine is heavy. Do not attempt to lift the machine without assistance. Incorrect lifting

techniques may result in personal injury.

PREPARING FOR USE

(4)

(1)

(2)

(3)

(5)

(1) Bottom handle

(2) Machine body

(3) Component housing

(4) Solution tank

(5) Top handle and solution cable

(6) Handle LH & RH

(7) Brush shafts (2)

(8) Screws & washers

(9) Cable retainer

(10) Power cord

(11) Dirty water tank

(12) Handle knobs

(6)

(7)

(8)

(9)

(10)

(11)

(12)

1. The Powr-Flite Multiwash 14 ships with the handle dismantled. To assemble, verify that all of the parts listed are

included.

2. Remove the hook, which holds the bottom handle with the machine body, while holding the bottom handle.

Warning! Since the bottom handle is spring loaded, care must be taken when removing the hook to

avoid sudden springing back, leading to possible injury to personnel.

UNPACK

ASSEMBLY

1. Insert the two tubular handles into the bottom handle and secure them using handle

knobs (12) by tightening lightly. Verify that the handles are assembled according to their

marked position and the cable holding hooks are pointing towards the rear.

2. Slide the electric cable retainer into the top portion of RH handle.

3. Fit the top handle over the tubular handles and secure them with a washer and screw

(2 sets). Ensure that the label on the top handle is facing the front of the machine. Now

ﬁrmly tighten both the knobs and screws alternately. Insert the dummy caps provided to

cover the screws (2) in the top handle.

4. Pass the free end of the pull cable through the plastic guide in RH Handle. Press and

twist clockwise to ﬁrmly secure the cable end to the ﬁtting in the component housing.

5. Fix the auxiliary tank ﬁrmly into the bottom handle by holding the top handle.

6. Rotate the knob to hold the auxiliary tank.

7. The brushes are only loosely packed in the machine for transit. The brush shafts must

be ﬁtted before operating the machine. Push the shafts through the brushes from the

side of the machine. To remove brushes, push the brush shaft out from the side of

the machine and remove the shaft. Normally the standard brush will be supplied with

the machine. Brushes should be selected according to the type of ﬂoor surface to be

cleaned and the type of dirt to be removed. Please refer Brush Selection Guide.

8. The machine is now ready for use.

RIGHT

BOTTOM

REAR

LEFT

BOTTOM

REAR