Product Manual

9
TROUBLESHOOTING
7. Place existing or new Drive Belt over Rotating Cleaning Brush and the motor shaft. Insert the
end cap pin on the left of the Rotating Cleaning Brush into the slot on the Powerfoot and slide
the end cap pin on the right end of the Rotating Cleaning Brush in to the slot in the Powerfoot
and lower until it clicks into place.
8. Make sure the Furniture Protection Guard is still intact.
9. Align the 3 tabs on the Top Cover with the 3 slots in the Powerfoot. Press into place, making
sure the Furniture Protection Guard is on the outside.
10. Grip both the top cover and bag while turning the vacuum cleaner face down.
11. Reinstall the 3 screws beginning with the center screw.
Vacuum cleaner won’t run.
Possible Causes Remedies
Vacuum Cleaner is not plugged in Check power Source Plug and Connector Plug
Household fuse/circuit breaker tripped Check/replace fuse – Reset breaker
Vacuum cleaner won’t pick up dirt.
Possible Causes Remedies
Dust Bag is full Replace with new Dust Bag
Drive Belt not functioning Realign Drive Belt or replace if damaged
Rotating Cleaning Brush bristles worn Replace Rotating Cleaning Brush
Rotating Cleaning Brush jammed
Remove Rotating Cleaning Brush and clean debris
from brush ends; Reinstall Drive Belt
Dust Tube is clogged Clean Dust Tube
Accumulation of dust inside Cloth Bag
Possible Cause Remedies
Dust Bag is clogged or dirty Replace with new Dust Bag
Dust Bag collar retainer not secure Secure Dust Bag collar retainer
Inlet clogged Shake dust down to bottom of Dust Bag.