Product Manual

Routine Maintenance

For maximum performance from your vacuum, check and maintain

vacuum parts regularly.

Replacing the Dust Bag

Check the Dust Bag weekly. Replace the Dust Bag when it is near full

or when cleaning suction diminishes. Never reuse a Dust Bag.

WARNING: To avoid electrical shock or injury from moving parts,

always turn OFF the Power Switch and unplug the Power Source Plug

before performing maintenance or trouble shooting. Always unplug by

grasping the Power Source Plug; NEVER pulling on the Power Cord to

unplug.

Tip: Vacuuming new carpet or vacuuming fine powders may clog the

Dust Bag. Check Dust bag often.

Unplug vacuum by grasping and pulling on the Power Source Plug.

Unzip Cloth Bag. Remove collar retainer by pressing on the two tabs

and pulling the top towards you. Dispose of Dust Bag.

Slide collar of new Dust Bag completely into collar retainer. Push

collar retainer back into position and secure in place.

Tuck the remainder of the Dust Bag completely inside the Cloth Bag.

Make sure it lays flat, top to bottom, without bunching. Zip Cloth

Bag.

Cleaning the Dust Tube

The vacuum features a Dust Tube designed to optimize cleaning

power. For best performance, routinely check and clear excess dust

and other debris.

Note: Cover floor with newspaper to catch any loose material or dust

removed during cleaning.

Release Bag Tension Spring.

Remove Filter Cover screw and then remove Filter Cover. Unplug

Connector Plug.

Locate the Tube Release Button at the top of the Powerfoot. The

Tube Release Button is hidden under a Rubber Collar on the side of

the Dust Tube and can be pressed through the Rubber Collar. Lift off

the Dust Tube while pressing on the Tube Release Button.

Use a wire brush to clean out the inside of the Dust Tube and the top section of the Powerfoot

where they connect.

Reconnect the tube with the Powerfoot. It should snap into place. Make sure that the tube

release button on the Tube lines up with the Tube Release Button on the Rubber Collar.

Plug the Connector Plug back into base of vacuum.

WARNING: To avoid electrical shock or injury from moving parts, always turn OFF the Power

Switch and unplug the Power Source Plug before performing maintenance or trouble shooting.

Always unplug by grasping the Power Source Plug; NEVER pulling on the Power Cord to unplug.