Product Manual

The wet use adapter must be installed prior to
using this vacuum for wet material recovery.
WET USE ADAPTER INSTRUCTIONS
This vacuum has been specifically designed to clean up
hazardous dust and debris. Special filters reduce the risk
of airborne dust that would be created by other methods
of cleaning.
BE SURE TO READ AND FOLLOW ALL SAFETY
INSTRUCTION!
THIS EQUIPMENT SHOULD BE OPERATED BY
TRAINED PERSONS AND IN ACCORDANCE WITH ALL
LOCAL REGULATIONS.
DO NOT sweep, scoop, shovel or in any manner handle
hazardous dust and debris other than by vacuum.
DO NOT at any time attempt to remove, substitute,
bypass or by any other means change the filters in the
vacuum.
Special filters are required for use in this hazardous waste
vacuum.
DO NOT use any other replacement filters, filter bags or
parts than the original equipment manufacturers.
DO NOT use without complete knowledge and under-
standing of set up, cleaning, replacing filters and filter
bags on this unit.
DO NOT use this vacuum without fully understanding the
manufacturer’s warnings, and proper use instructions.
DO NOT EXPOSE HEPA
FILTER TO WATER
DO NOT ATTEMPT TO RECOVER
ANY WET ITEMS WITHOUT FIRST
INSTALLING THE WET ADAPTER
LEAVE HEPA PRE-FILTER IN PLACE
DURING WET RECOVERY
INFORMATION
The PF55HM has been specifically designed to recover
hazardous material. The PFHMW-K is the wet recovery
adapter that must be used whenever wet materials are
going to be recovered with the PF55HM.
DESCRIPTION
The PFHMW-K is designed to move the HEPA filter out
of the recovery tank to prevent it from getting wet. This
adapter is composed of two parts:
1. A stainless Steel Spacer (Fig. 1)
2. A float shut-off assembly (Fig. 2)
The stainless spacer moves the HEPA filter out of the
recovery tank and the float shut off prevents water from
entering the tank.
Fig. 1
Fig. 2
4