Product Manual

6
EXHAUST FILTER REPLACEMENT
BELT ADJUSTMENT AND REPLACEMENT
VACUUM MOTOR FILTERS
MACHINE MAINTENANCE
FOR BEST PERFORMANCE
CAUTION: Unplug the vacuum cleaner
before performing the following steps.
• Keep machine and all accessories clean
and in good operating condition.
• Change vacuum bags and filters as
recommended to maintain optimum
cleaning efficiency.
• Always use genuine bags, filters and
parts, as use of other products may result
in poor cleaning or filtration performance.
OEM filtration products are designed for
maximum performance.
• Have machine checked periodically by an
authorized service representative.
• Store machine carefully in dry area.
• For optimum cleaning performance and
safety, follow your owner’s manual.
• After each use, carefully wrap power cord
around handle and check cord for wear
or damage. If cord is damaged, have
power cord replaced by an authorized
service representative immediately
1. Carefully turn machine on its side and
remove exhaust cover from bottom of
machine.
2. Remove the two nuts holding filter onto
machine.
3. Replace filter in proper position and tighten
nuts.
4. Reinstall exhaust cover.
*Replace exhaust filter every 6 months.
1. Remove belt cover on left side of machine.
2. Loosen the motor belt adjusting screws on
motor bracket.
3. Remove belt.
4. Install new belt and reposition motor to
eliminate excess slack.
5. Once proper tension is set, tighten motor
adjusting screws.
6. Replace belt cover on side of machine.
• Position the handle in normal operating
position.
• Open Wide Area Vacuum lid and rest it
on the handle.
• Remove clamp with a screwdriver to gain
access to filter
• Remove plastic cap covering the motor
• Remove plastic retainer in cap
• Replace filters in their original positions.
• Reinstall plastic retainer in cap
• Reinstall cap onto motors
• Reinstall clamp.
*Replace the vacuum motor filter every 6
months.