Product Manual

5
HANDLE ADJUSTMENT
BAG INSTALLATION
BRUSH HEIGHT ADJUSTMENT
OPERATION OF MACHINE
1. Loosen handle lock lever and adjust handle
to comfortable operation height
2. Tighten lever to lock handle in place.
1. Position the handle in normal operating
position.
2. Open bag compartment lid and rest it on the
handle.
3. Unzip cloth bag and install paper bag inside.
4. Attach both bag openings together onto
vacuum intake housing.
5. Make sure bag is properly deployed inside
machine housing.
6. Completely close zipper on cloth bag and
close lid of machine.
ATTENTION: Never operate machine without
cloth bag. Always use cloth and paper bags
together.
1. This machine has 5 brush adjustment levels.
2. To raise brush height level: lift up height
adjustment bar until desired brush height is
attained.
3. To lower brush height level: push down
on height adjustment bar until desired brush
height is attained.
1. Plug power cord into properly grounded
power outlet.
2. Click the on/off switch on to the ON position
to turn on machine.
3. To operate brush squeeze the brush start
triggers.
4. Adjust brush height for proper pick-up.
CIRCUIT BREAKER
Your new wide area vacuum comes equipped
with two manual circuit breakers, a 15 amp
breaker for the vacuum motor and a 2.5 amp
breaker for the brush motor. If the machine
does not turn on you will need to check the
circuit breakers.
To reset circuit breakers:
1. Unplug the wide area vacuum cleaner
2. Check machine for the following:
Full bag, obstructions, clogged filters, clogged
brush, brush height set too low, etc.
3. Press the affected circuit breaker button to
reset.
4. Resume operation