Use and Care Manual

Air
Movement!
OPERATING INSTRUCTIONS
MAINTENANCE/TROUBLE SHOOTING
1. Plug in to a standard outlet with the correct voltage and amperage for the unit.
2. Place the dryer in the desired operating position.
3. Set the s
witch at the desired speed: low or high.
4. Check for proper operation before leaving the unit unattended.
Do not move or carry the dryer when it is running.
5 AMP Resettable Circuit Breaker
The F6 Whole Room Dryer™ features a 5 amp circuit breaker that will “trip” if more
than 5 amps of electrical current is drawn through the cord.
Operating Positions
The F6 is designed to operate in multiple positions for any type of drying.
1.
Face Down – Set the F6 on the four caster wheels to direct air straight down.
Turn each caster to a 45° angle to the housing for best airflow.
2.
Tilt Back – Tilt the F6 backward on the four curved molded legs at an angle
to direct air for elevated drying.
3.
Upright – Set the F6 square with the handle on the top to direct air across
a room.
4.
Tilt Forward – Tilt the F6 forward on the “standing legs at an angle to direct
airflow along the flow in front of the dryer.
5.
Stack for Storage – the F6 Powr-Dryer interlock and stack for easy
storage and transport.
Periodic Maintenance
1. Check power cord for any breaks, seperations or cuts.
2. Make sure the ground pin or grounding prong is intact or
the machine will be unsaf
e to oper
ate
.
T
r
ouble Shooting
(if the dr
y
er will not r
un)
1. Check electrical cord; is it firmly seated in wall outlet
2. Check if dryer circuit breaker is tripped, reset if necessary.
3. Check to see if building circuit breaker is tripped. If circuit
is o
v
er
loaded, mo
v
e cord to a different outlet.
4. If using an extension cord, make sure it is in good
condition, proper gauge and fir
mly connected.