Instruction Manual

4
OPERATING INSTRUCTIONS
1. Plug in to a standard outlet with the correct voltage and amperage for the unit.
2. Place the dryer in the desired operating position.
3. Set the switch at the desired speed: low or high.
4. Check for proper operation before leaving the unit unattended.
Do not move or carry the dryer when it is running.
Daisy-chained: Up to 6 units may be plugged into on a single 15 amp circuit and up to 9 on a
20 amp circuit. The F5 is equipped with dual power outlets that will allow you to “daisy chain”
up to 5 units units. Do not “daisy chain” more than 5 units. The F5 power system has a 12
amp circuit breaker built in that will trip if more than 5 units are “daisy chained” from a single
machine.
12 AMP Resettable Circuit Breaker
The F5 Powr-Dryer features a 12 amp circuit breaker that will “trip” if more than 12 amps of
electrical current is drawn through the cord.
GFCI Protection and Outlet
The F5 Powr-Dryer provides a standard duplex GFCI outlet for daisy-chaining multiple units
together. The GFCI protection promotes operator safety and will “trip” is an electrical ground
fault is sensed. To test the GFCI protection, press the TEST button. If operating properly, the
RESET button on the GFCI outlet will pop out.
Operating Positions
The F5 Powr-Dryer is designed to operate in multiple positions for any type of drying.
1. Tilt Back – Tilt the F5 backward on the four curved molded legs at an angle to direct air for
elevated drying.
2. Upright – Set the F5 square with the handle on the top to direct air across a room.
3. Tilt Forward – Tilt the F5 forward on the “standing legs at an angle to direct airflow along the
flow in front of the dryer.
4. Face Down – Set the F5 on the four curved molded legs with the “standing legs” facing up to
direct air straight down.
5. Powr Pitch – Model PDF5 is equipped with a 3º down angle leg.
6. Stack for Storage – the F5 Powr-Dryer interlock and stack for easy storage and transport.
2 postion switch and daisy-chained outlets Cord wrap