Owner's manual

6
We remind you that packing material (wood,
nails, paper, cellophane, metal staples,
adhesive tape, straps, ropes, etc.) may
cause cuts or wounds and should be handled
with care. These must be removed with
appropriate tolls and should not be left in
the care of irresponsible people ( e.g. Children);
the same applies to the unpacking tools
(scissors, hammers, pliers, knives, etc..).
On specific request, Powr-Flite will pack the
machines appropriately but this does not
eliminate the above safety notes.
During movement, suspended loads made up
of machine components or parts represent
a collision, risk, it is the responsibility of the
customer to highlight this danger.
WARNING: before attempting to adjust or
prepare the machine or to fill the tanks, make
sure that the power supply is disconnected.
Solution Tank: The detergent tank is positioned
underneath the upper cover at the front of
the machine with the filter hole M1 easily
accessible for easy refilling.
Before filling the tank with correctly diluted
detergent, empty the waste collection tank as
described in the following paragraph; obviously
this step is not required for the first time of
filling.
The capacity of the solution tank is 17 gal. only
use the quantities and dilution recommended
by the detergent supplier and use only non-
foaming detergents. If foam is created, use
a defoaming chemical in recovery tank.
Recovery Tank: The waste tank should be
emptied (preferably after each use) so as not
to let the dirt settle; to do this, remove the
cap covering the drain tube M2 which is held
in place by a retaining spring, and put in a
position so that it drains. Always abide by the
environmental regulations of the country where
the machine is used.
Squeegee Blade: The floor squeegee serves
to finish the drying operation and it is very
important to ensure it is in the correct
position: lower the squeegee to its working
position using the foot pedal M3; level the
squeegee using the knobs M4 so that the
black rubber strip is approximately 1 mm
above the floor.
The remaining rubber strips must wipe the floor
with a certain amount of pressure; after the first
few hours of operation the rubber squeegees
adapt themselves to the inclinations and the
drying action improves. The pressure of the
squeegees on the floor is regulated by pressing
the knob.