OPERATOR’S MANUAL Predator Automatic Scrubber 20 Model PAS20DX WARNING: OPERATOR MUST READ AND UNDERSTAND THIS MANUAL COMPLETELY BEFORE OPERATING THIS EQUIPMENT.
IMPORTANT SAFETY INSTRUCTIONS All operators must read, understand and practice the following safety instructions. They will be repeated occasionally throughout this manual, and additional cautions may be added for specific cases. • CAUTION: Operators must read and understand this manual completely before • CAUTION: Make sure the charger has operating this equipment. turned off before disconnecting it from the batteries.
This manual refers to a battery powered automatic floor scrubber. Designed to be simple, easy to operate and safe, with maneuverability and automatic variable electronic drive. Routine maintenance has been simplified and reduced to the minimum to keep equipment on the job. The floor cleaner is intended for cleaning and washing level floors in closed spaces using appropriate detergents. This manual serves to guarantee the correct use of the machine thus supporting the service that we offer the customer.
Powr-Flite declines all responsibility for damage of any kind resulting from imprudent use by expert or inexpert personnel who have not operated the machine in accordance with this manual. The installation must be carried out in accordance with the laws in force in the country where it is installed; Powr-Flite is not responsible for equipment upstream of the cleaner. The customer must use exclusively original spare parts and fit them in the intended way.
If the cleaner is left unattended remove the key from the main power switch. The machine generates a sound pressure level (noise) in an industrial environment (warehouse/ shop floor) which is less than 80 dBA and is therefore absolutely harmless for the operator. However, in other surroundings, this level may be exceeded in which case the customer must provide appropriate protection (ear defenders) as well as notices to promote their use and periodic hearing examinations.
We remind you that packing material (wood, nails, paper, cellophane, metal staples, adhesive tape, straps, ropes, etc.) may cause cuts or wounds and should be handled with care. These must be removed with appropriate tolls and should not be left in the care of irresponsible people ( e.g. Children); the same applies to the unpacking tools (scissors, hammers, pliers, knives, etc..). On specific request, Powr-Flite will pack the machines appropriately but this does not eliminate the above safety notes.
• Finally, use lever M12 to regulate the dosage of detergent according to the amount of dirt and the speed of the machine. Particularly dirty floors: Certain floors or environments require particular attention or even a second pass with the cleaner. In this case you should make on pass with the wiper raised and the brush in the working position; in this way the detergent remains on the floor for longer and will dissolve the tougher dirt.
TROUBLESHOOTING Trouble Possible Cause The machine does not start up Low battery Main fuse blown Control Card Fault Possible Solution Ensure battery is charged Replace fuse* Replace Control Card The machine does not move Defective handle switch Blown fuse Check/Replace handle switch Replace fuse The brush does not rotate Blown fuse Replace fuse The vacuum does not work Blown fuse Defective vacuum switch Replace fuse Check/replace switch The squeegee does not recovery completely Vacuum switched O
For warranty information go to www.Powr-Flite.
