OPERATOR’S MANUAL Automatic Scrubber PAS20BA-BC WARNING: OPERATOR MUST READ AND UNDERSTAND THIS MANUAL COMPLETELY BEFORE OPERATING THIS EQUIPMENT.
TABLE OF CONTENTS Safety Instructions.............................................................................. 3 Machine Set-Up................................................................................... 4 Machine Specification......................................................................... 4 Replacement Parts:............................................................................. 8 Brush..............................................................................................
SAFETY INSTRUCTIONS FOR COMMERCIAL USE READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE • • • • • • • • • • • • • • • • • • • Use indoors only. Do not expose to rain. Do not allow it to be used as a toy. Use caution when operating near children. Use only as described in this manual. Use only manufacturer’s recommended accessories. Charge batteries in a ventilated room. Gases given off during charging could ignite in a confined space.
Machine Set-Up 19 20 1 21 2 22 18 3 17 4 16 5 15 6 14 13 12 1. 2. 11 9 10 Handle Bar Control Panel a.... Hour Meter b.... Battery Condition Indicator c.... Brush Motor Switch d.... Vacuum Motor Switch e.... Solution Switch Squeegee Release Handle Brush Lift Pedal Wheel, Bump Squeegee Mount Knob Squeegee Squeegee Tilt Knob Water level sight tube 3. 4. 5. 6. 7. 8. 9. 8 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22.
Daily Operation and Maintenance How to Install Batteries Caution: Batteries are heavy. Install (2) 12-volt deep cycle batteries. New Batteries should be given a full charge before first use. 1. 2. 3. 4. Unplug the hoses (20, 21) from the recovery tank (19). Make sure the recovery tank is empty then lift it up. Place batteries on the tray. Use the bracket to secure them. Position them correctly. Connect all the cable terminals.
How To Operate The Machine 1. To turn the power on, turn the key switch (22). The power/battery indicator (b) will light up. 2. Check the battery capacity to see if it is full – all indicators are lit up when batteries are fully charged. 3. To turn on the brush motor, vacuum motor and the solution flow, press the switches (c,d,e). Turn off the brush motor when the brush deck is in the up position. How to Turn the Vacuum Motor On and Off 1. Push the top half of the right switch (d) down.
What to Do When Operating The Machine Vacuuming Up Solution 1. Make sure the squeegee is in the down position. 2. As the machine moves forward and solution is dispensed, the squeegee will vacuum it up into the recovery tank. 3. If necessary adjust squeegee pressure by turning knob (8). If solution is missed, reduce the amount of solution flow, raise the squeegee and pull the machine back over the missed area. Lower the squeegee and move the machine forward to pick up any remaining solution.
Troubleshooting WARNING - Before performing maintenance or making adjustments, switch off the machine and disconnect the battery. Problem: Possible Cause: Solution is not being picked up Vacuum motor is not running Water filter is clogged Recovery tank is full Squeegee or vacuum hose is clogged, broken or disconnected Bad seal at tank cover, vacuum motor or squeegee Worn or misaligned squeegee blades. Incorrect squeegee pressure.
Powr-Flite Warranty Statement All Powr-Flite equipment has been tested and inspected at the factory and is guaranteed to be free from defects in material and workmanship for the duration described below. For full details, contact your authorized Powr-Flite Distributor, Service Center, or the Powr-Flite Technical Service Department.
