Product Manual

7
oPeratIng InStructIonS
Please read the following instructions carefully. They will help to get the best performance from this professional
commercial vacuum cleaner and to maintain it in optimum condition. Always make sure the main power of the
vacuum is off and the unit is not plugged in when doing any maintenance on the vacuum.
PREPARING TO VACUUM
1. Remove vacuum hose from top of unit. (Fig. 1)
2. Release the two latches and lift off lid. (Fig. 2)
3. Ensure Micro Cloth bag is fully seated on Comfort Pro tank
housing. (Fig. 3)
4. Fold the bottom 2” of the HEPA bag up and hold into place.
(Fig. 4)
5. Insert HEPA bag inside of micro cloth bag. (Fig.5)
6. Squeeze bag just below the cardboard collar and drop onto
rubber gasket. (Fig. 6)
7. Ensure that white bag is not protruding under cardboard
collar. (Fig. 7)
8. NOTE: Cardboard must be properly seated inside gasket
groove. Cardboard will be flush with gasket. (Fig. 8)
9. Replace lid, lock down the two latches and install hose.
(Fig. 9).
OPERATING THE BACKPACK VACUUM
1. Fasten the ends of the top and bottom wand together.
2. Attach the floor tool to end of wand. Align the steel ring with
the groove on the floor tool to ensure a secure fit and
tighten.
4. Turn the unit on, and proceed with vacuuming.
5. The on/off switch is conveniently located on the body of the
backpack vacuum (Fig. 10)
PROPER VACUUMING MOTION FOR LARGE AREAS
1. Begin with the wand parallel to your body.
2. Draw the top of the wand in toward your waist and twist at
the waist walking backward or forward, in a side-to-side
motion.
3. The motion is similar to mopping and keeps the upper body
and arms from tiring.
IMPORTANT!
PERFORM PROPER INSTALLATION OF HEPA BAGS AND CORD
IN COMFORT PRO BACKPACK VACUUMS.
1.
2.
3.
5.
4.
7.
8.
9. 10.
6.