Product Manual

CHANGING THE BRUSH

WARNING – This has been designed for use with the brushes specified by the

manufacturer. The fitting of other brushes may affect its safety.

Always ensure machine is unplugged before fitting or removing parts.

1. To change the brush, first remove both the recovery and solution tanks.

2. Move handle to upright position, pull backwards and downwards to rest on

the floor with the base raised.

3. Push end of brush shaft with a finger and withdraw shaft completely.

4. Place new brush in position and insert shaft through brush until it clicks

into place.

5. Return machine to the floor, replace tanks and reconnect hoses.

Changing squeegee blades

The squeegee blades are self adjusting for wear. However, when wet pick-up

becomes ineffective, or blades are damaged they should be replaced.

1. Raise machine base as for a brush change.

2. Slide squeegee blades out sideways from the holder.

3. Slide new blades into place with the ribbed side facing outwards.

4. Return machine to the floor, replace tanks and reconnect hoses.

STORAGE

1. When cleaning is finished, unplug the machine from the power supply and lift

off and empty the recovery and solution tanks over a suitable sink or drain.

2. Flush out the recovery tank with clean water.

3. Replace tanks and wipe the machine with a damp cloth. Wipe squeegee

blades clean.

IMPORTANT – Dispose of unused cleaning solution in accordance with the

manufacturer’s directions.

4. Remove brush and wash in warm soapy water, rinse and allow to

dry naturally.

After use always wipe down and dry the machine and remove and clean the

brush. The solution tank and recovery tank should be emptied and flushed out

with clean water. When storing the machine for long periods, raise the base

to protect the brush and squeegee from possible distortion. Wrap power cord

around the handlebar and cable winder, ensuring that the plug is not trailing on

the floor. Fold handle down as necessary. Store the machine in a dry indoor

area only.

Withdraw shaft completely.

Slide squeegee blades out sideways from the holder.

Clean and inspect spray bar.

MAINTENANCE