Use and Care Manual

Always unplug machine before cleaning, or making any

adjustments or repairs.

The backpack vacuum has four levels of ltration: the paper vacuum bag, a micro

cloth lter, a pre-motor lter and an exhaust lter. These bags and lters capture

ne dust particles and protect the motor from dirt. It is important to replace the

paper bag when it is no more than ½ full and to clean the lters on a regular

schedule and replace as necessary.

Paper Vacuum Bag

1. Remove paper bag. Insert a new paper bag into the cloth bag, making sure the

cardboard disk is centered on the exible sealing ring. When you replace the lid,

the short nozzle in the center of the lid will be closed over the central hole of the

cardboard disk of the paper vacuum bag providing a seal. (Fig. A)

2. Replace the lid. Fasten latches and replace hose. (Figs. C-D)

Micro Cloth Filter

After each use, the cloth lter bag should be inspected. Wash the cloth lter bag

every 6 months using cold water and no detergent. Line dry.

3. Remove the micro cloth bag, clean and replace. (Fig. B)

4. Replace paper vacuum bag and lid. Fasten latches and insert hose. (Figs. C-D)

Pre-Motor Filter

The pre-motor lter is located under the micro cloth lter. Inspect after each use.

The lter can be washed using cold water and no detergent. Lay at to dry. Replace

every 6 months.

5. Remove the lid, the paper vacuum bag, and the cloth bag to expose the pre-

motor lter.

6. Remove the foam pre-motor lter from the dust compartment, clean and replace.

If lter is extremely dirty, rinse out and air dry before replacing back into vacuum.

(Fig. E)

7. Reinstall the cloth bag, the paper vacuum bag and replace the lid, fasten latches

and insert the hose. (Figs. C-D)

Exhaust Filter

The exhaust lter is an easy-access washable, reusable post-motor lter located on

the bottom of the vacuum. For average use of the vacuum, remove and clean the

exhaust motor lter every 3 months. The lter can be washed using cold water and

no detergent. Lay at to dry. Replace once a year.

8. Remove the foam post motor lter, clean and replace.

9. Reinstall the lter at the bottom of the vacuum. (Fig. F)

800.880.2913

WARNING!