User Manual

10
Self-Cleaning
The self-cleaning function helps
remove pulp build-up, which improves
the performance of the juicer. Using the
self-cleaning function can also make
fully cleaning the juicer easier. To use
the self-cleaning function:
1. Place an empty cup underneath
the Spout.
2. While slowly pouring water into
the Chute, lightly press the Self-
Cleaning Button three times. The
cleaning Attachment will scrape off
any excess pulp.
3. Stop pouring water and let the
water drain.
4. Remove the cup with water.
5. After using the self-cleaning
function, you can either continue
juicing or shut off the juicer. If you
shut off the juicer, the juicer should
be fully cleaned (see the “Fully
Cleaning the Juicer” section).
Care & Cleaning
3. Remove the self-cleaning brush
from the Lid by unscrewing the
single screw closest to you
(see Fig. C).
Reassembling
the Self-Cleaning
Attachment
1. Reassemble the cleaning
attachment in the following
order: spring, washer, cleaning
brush, washer, screw.
2. Hand tighten the screw so it is
snug and will not fall off when in
use. Do not overtighten to strip
the screw.
3. For best results, ensure that the
screw is screwed in all the way
before each use.
FIG. C
Disassembling
& Cleaning the
Self-Cleaning Attachment
1. Pull down the locking bar.
2. Remove the Lid and Pulp Guard
and turn it over.
4. The screw, washer, cleaning brush,
washer, and spring will slide off of
the self-cleaning rod.
5. Clean or replace the Self-Cleaning
attachment. Contact customer
service for replacement parts.