Use and Care Guide
25
MAINTENANCE
Normal maintenance, replacement or repair of emission control devices and systems may be
customer service for assistance.
WARNING
When servicing, use only recommended or equivalent replacement parts. Use of any other parts
WARNING
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so
could result in objects being thrown into your eyes resulting in possible serious injury.
WARNING
Before inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to
stop, and disconnect spark plug wire and move it away from spark plug. Failure to follow these
instructions can result in serious personal injury or property damage.
NOTICE
Periodically, inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
WARNING
come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which
could result in serious personal injury.
Before running the engine, perform the following preoperation steps:
• Check that all bolts, nuts, etc., are securely tightened.
•
•
•
• If there is excessive noise or vibration, stop the unit immediately.
NOZZLE MAINTENANCE(See Figure 14)