Use and Care Guide

OPERATION

USING THE SPRAY WAND TRIGGER (See Figure 11)

WARNING

Hold the trigger handle securely with both hands. Expect the trigger handle to move when the

trigger is pulled due to reaction forces. Failure to do so could cause loss of control and injury to

yourself and others.

• Pull back and hold the trigger to operate the pressure washer.

• 



• Push the lock out down until it clicks into the slot.



• Push the lock out up and into its original position.

NOTE: Start with the nozzle 1-2 ft. away from the cleaning surface and carefully approach

the surface just until the desired level of cleaning is achieved. If the spray is too close it can

damage the cleaning surface.

Locked

Unlocked

USING THE SPRAY TIPS (See Figure 12)

Each of the spray tips has a different spray pattern. Before starting any cleaning job, determine

the best spray tip for the job. The following chart offers some general guidelines to help you

choose the best spray tip for your application.

!"#$

• Turn off the pressure washer and shut off the water supply. Pull trigger to release water

pressure.

• Engage the lock-out on the trigger handle by pushing the trigger lock button to the right.

• Pull out the desired spray tip from the tip storage on the handle.

• Pull back the quick-connect collar on the spray wand.

• Push the spray tip into place in the spray wand.

• Push the collar forward so that the spray tip is secured properly. Check to see that the spray tip

is secure.

Fig. 11