Use and Care Guide

ASSEMBLY

Fig. 5

Outlet

Connector

High Pressure

Hose

CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE

See Figure 5.

• Align the pressure hose with the trigger handle and push up and into position.

• With hose pushed into position on the trigger handle, secure in place by turning the hose lock

clockwise until fully tightened.

①

②

NOTE: For easier installation of the hose to the unit or trigger it is suggested to add pressure

washer or dish detergent to the rubber seal at each end of the hose. This will allow for easier



CONNECTING THE HIGH PRESSURE HOSE TO WATER OUTLET

See Figure 6.

• Remove the hose connector cap.

• Connect the other end of the hose to the hose connector, secure in place by turning the hose

lock clockwise until fully tightened.