Manualshelf

User Manual

ManualsBrandsPowerwinch ManualsAccessories for waterSport Fish 450
12345678910
POWERWINCH SPORT FISHING 450 ANCHOR WINCH
7
Anchor
Winch
Green
Black
Red
6awg
Black 6awg
Control
Switch
Black
6awg
PW46004
Ring Terminals
1/4-20 x 1/2
Screw & Nut
Tape or
Heat Shrink
= Mechanical Connection
Red
12awg
Black
12awg
Red 6awg
25A Circuit Breaker
Battery
Black
12awg
Red
12awg
(A) (B)
(C) (D)
11. Connect the motor GREEN wire to the new RED wire with a 1/4 -20 screw and nut.
Position the wrap and lightly heat until it shrinks around the terminals.
12. Connect the motor B
LACK wire to the new BLACK wire with a 1/4 -20 screw and
nut. Position the wrap and lightly heat until it shrinks around the terminals.
13. At the switch position, terminate the ends of the new wires with 5/16" 6 awg
ring terminals.
14. Connect the switch R
ED wire to the winch RED wire with a 1/4 -20 screw and nut.
Position the wrap and lightly heat until it shrinks around the terminals.
15. Connect the switch B
LACK wire to the winch BLACK wire with a 1/4 -20 screw and
nut. Position the wrap and lightly heat until it shrinks around the terminals.
16. Route 1 R
ED and 1 BLACK 6 awg wire from the battery to the switch location.
Be sure to allow adequate wiring to make connections, allow the wire to
have some slack when routing. Secure the wires with wire ties.
17. At the switch position, terminate the ends of the new wires with 5/16" 6 awg
ring terminals.
18. Connect the switch R
ED wire to the battery RED wire with a 1/4 -20 screw and nut.
Position the wrap and lightly heat until it shrinks around the terminals.
19. Connect the switch B
LACK wire to the battery BLACK wire with a 1/4 -20 screw and
nut. Position the wrap and lightly heat until it shrinks around the terminals.
20. Push the switch and wires into the switch mounting hole. Secure the switch plate
using 4 #10 screws.
21. At the battery location, terminate each wire with a 5/16" ring terminal.
22. Attach the B
LACK wire to the negative (-) post of the battery.
23. Attach the R
ED wire to the post on the circuit breaker.
24. Attach the circuit breaker to the positive (+) post of the battery.