r Manual

POWERWINCH CAPSTAN POWERED LIFT ASSIST
7
OPERATING THE WINCH
The Capstan can be used to retrieve anchors, traps or pots; these are referred to
as the "load" in the directions below.
LOADING THE ROPE
1. Thread the rope through the davit or bow roller and pull back to the winch.
2. Wrap the rope counterclockwise 4-5 wraps around the capstan.
CAUTION ALWAYS SECURE THE ROPE TO A DECK CLEAT OR SIMILAR DEVICE. DO
NOT USE THE WINCH TO TIE OFF THE LOAD.
CAUTION ALWAYS USE THE RECOMMENDED ROPE (SEE PAGE 2). USE OF
DIFFERENT ROPE CAN CAUSE PROPERTY DAMAGE AND PERSONAL INJURY
.
LOWERING THE LOAD
1. Turn boat into wind and place boat motors in neutral.
2. After the boat has stopped all forward progress, release the rope from the
deck cleat. Allow the load to free fall to the sea bed.
CAUTION NEVER USE THE WINCH TO LOWER THE LOAD OR TO BRAKE THE LOAD
DURING FREE FALL
. THIS CAN RESULT IN SERIOUS DAMAGE TO THE GEAR TRAIN.
3. After the desired amount of rope has been released, tie the rope off to a
deck cleat. D
O NOT use the winch to tie-off the anchor.
4. For anchors, place the boat's motors in neutral and allow the boat to drift
back and set the anchor in the sea bed.
RETRIEVING THE LOAD
1. Untie the rope from the deck cleat.
2. Align bow of boat with load.
3. Place the boat's motors in forward and
move boat slowly toward the anchor
point.
4. Press the winch switch and pull the
rope hand over hand.
NOTE: The rope must be kept under
tension for the winch to work properly.
5. After the load is secured, tie the
rope off to a deck cleat. D
O NOT
use the winch to tie-off the load.
MAINTENANCE
Following each boat outing, flush exterior of winch with fresh water. Use only
mild detergents to clean exterior. Use of solvents can cause damage to the
finishes and seals, as well as void product warranty
Every 6 months inspect capstan for wear. Replace any worn components.
Check rope periodically for abrasion or deep cuts. Never splice an old rope with a new
rope. If replacement is necessary, use only Powerwinch recommended rope.
Check electrical connections every 6 months for corrosion. Replace any
connection or wire which is damaged, corroded, frayed or worn.
pwcs002
Pull Rope Hand over
Hand While Pressing
the Foot Switch
Wrap Rope
4-5 Times
Counterclockwise
Foot Switch