User's Manual

USU

 USER MANUAL

DCM000000104

Printed: 03.05.21,10:40

Revision Date:5/21/03

• All Antenna Installation to be performed by Qualified Technical Personnel only.

• Antenna Installation Instructions and locations below are for the purpose of

satisfying FCC RF Exposure Compliance requirements.

• The In-Building Antenna connection is via a coaxial cable distribution system

with Signal Taps at various points connected to the fixed-mounted Indoor

Antennae. This is shown in the figure in the Introduction. The Indoor Antennae

are simple 1/4 Wavelength (0 dB Gain) types. Please consult Kaval Wireless for

assistance as required. These Antennae are to be installed such that no person

can touch the Antenna, or approach within 0.2 Meters.

ANTENNA INSTALLATION

WARNING

ALL ANTENNA INSTALLATION IS TO BE PERFORMED BY QUALIFIED

TECHNICAL PERSONNEL ONLY.

ANTENNA INSTALLATION INSTRUCTIONS AND LOCATIONS ARE FOR THE

PURPOSE OF SATISFYING FCC RF EXPOSURE COMPLIANCE

REQUIREMENTS, AND ARE NOT OPTIONAL.

ALL IN-BUILDING ANTENNAE INSTALLATIONS MUST BE SUCH THAT NO

PERSON CAN TOUCH THE ANTENNAE, OR APPROACH CLOSER THAN 0.2

METERS.

• This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provided reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference

to radio communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be required to

correct the interference at his own expense.

WARNING

CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY KAVAL

COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

Antenna Installation

FCC Information to

Users