User's Manual
Table Of Contents
- Overview
- Standard Models
- Filter Kits
- Accessories
- Accessories for Stainless-Steel Weather-Resistant Enclosures
- Fiber Optic Options
- Installation
- RF Deck Connections
- Battery Backup
- In-Hancer Plus BDA Specifications
- Carrier De-Rating
- Indicators
- Configuration
- Antenna Installation
- FCC Information to Users
- Maintenance & Safety
- Standard Warranty
- Return & Repair
- Parts & Accessories
In-Hancer Plus BDA
USER MANUAL
DCM000000105
Antenna Installation
•
•
•
•
•
All Antenna Installation to be performed by Qualified Technical Personnel only.
Antenna Installation Instructions and locations below are for the purpose of
satisfying FCC RF Exposure Compliance requirements.
The Roof Top Antenna or Antennae for linking to the Donor Site(s) is/are
directional (high gain) Antennae, fixed-mounted physically on the side or top of a
building, or on a tower. The Antenna Gain must be no more than 20 dBi. The
Roof Top Antennae location should be such that only Qualified Technical
Personnel can access it, and that under normal operating conditions no other
person can touch the Antenna, or approach within 7 meters of the Antenna.
For the Cellular Uplink Band (824-849 MHz) the Roof Top Antenna or
Antennae for linking to the Donor Site(s) has the added restriction that the
Effective Radiated Power (ERP) must not exceed 7 Watts (+38 dBm). Thus, if
the AGC is set (as per the Carrier De-Rating Chart) to +28dBm as an example,
the maximum allowed Antenna Gain must be no more than 10 dBi.
The In-Building Antenna connection is via a coaxial cable distribution system
with Signal Taps at various points connected to the fixed-mounted Indoor
Antennae. This is shown in the figure in the Introduction. The Indoor Antennae
are simple 1/4 Wavelength (0 dB Gain) types. They are used with KAVAL
WIRELESS TECHNOLOGIES 12, 16, or 20 dB Cable Taps. As such the
maximum EIRP will be at the first Tapped Antenna, which will be 12 dB below
the maximum signal level of the BDA (+40 dBm); +28 dBm, or 0.63 Watts EIRP.
These Antennae are to be installed such that no person can touch the Antenna,
or approach within 0.2 Meters.
ANTENNA INSTALLATION
WARNING
ALL ANTENNA INSTALLATION IS TO BE PERFORMED BY QUALIFIED
TECHNICAL PERSONNEL ONLY.
ANTENNA INSTALLATION INSTRUCTIONS AND LOCATIONS ARE FOR THE
PURPOSE OF SATISFYING FCC RF EXPOSURE COMPLIANCE
REQUIREMENTS, AND ARE NOT OPTIONAL.
ALL ROOF TOP ANTENNA INSTALLATION MUST BE SUCH THAT NO PERSON
CAN TOUCH THE ANTENNA, OR APPROACH CLOSER THAN 7 METERS.
ALL IN-BUILDING ANTENNAE INSTALLATIONS MUST BE SUCH THAT NO
PERSON CAN TOUCH THE ANTENNAE, OR APPROACH CLOSER THAN 0.2
METERS.
Please consult Kaval Wireless for assistance as required.
Printed: 03.10.14,09:37
Revision Date:10/14/03
25